Filter
Top Products
Default Packet Size [128]
Maximum Packet Size [256]
Circuit Idle Time [30]
Maximum VCs [6]
QLLC example:
X.25 Config> change prot
Protocol [IP]? dls
Idle Timer [30]?
QLLC response timer (in decaseconds) [15]?
QLLC response count [255]?
Accept Reverse Charges [N]?
Request Reverse Charges [N]?
Station Type (1) PRI (2) SEC (3) PEER [3]?
Max Packet Size [256]?
Packet Window size [7]?
Max message size [2048]?
Call User Data (in HEX, 0 for Null) []? C3010000525450
pvc Changes PVC, window size, and packet size definitions.
Note: To change the protocol, packet channel or destination X.25 address,
you must delete the record which contains the definition, then add it
back with the changed parameters. A change will apply to
all
PVCs
in the range of circuits defined by the Packet Channel Range Start
parameter.
Example:
change pvc
Protocol [IP]? IP
Packet Channel Range Start[1]?
Destination X.25 Address [ ]?
Packet Channel Range End [1]
Window Size [2]?
Packet Size [128]?
Delete
Use the delete command to delete an X.121 address, a protocol configuration
definition, or a PVC definition.
Syntax:
delete
address
bi-cugs
cugs
protocol...
pvc
address
Deletes an X.121 address translation.
Example: delete address
IP example:
Protocol [IP]?
IP Address [0.0.0.0]?
IPX example:
Protocol [IP]? IPX
IPX Host Number (in hex) [2]?
Configuring the X.25 Network Interface
Chapter 27. Configuring and Monitoring the X.25 Network Interface 349
|
|
|
|
|
|
|