Filter
Top Products
Notes:
1. The configuration for group 1 starts at 1.
2. The configuration for group 2 starts at 2.
Config>protocol brly
BSC Relay protocol user configuration
BRLY config>add group 1
Local group number: [1]?
Point to Point connection?(Yes or [No]):
BRLY config>add local
Local group number: [1]?
Interface number: [0]? 1
(P)rimary or (S)econdary: [S]? p
Does this interface communicate with multiple remote groups [N]? y
BRLY config>add remote
Local group number: [1]?
IP address of remote router: [0.0.0.0]? 6.6.6.1
Remote router group number: [1]?
(P)rimary or (S)econdary: [S]? s
Station address in hexadecimal (1 - FF): [1]? c1
BRLY config>li all
BSC Relay Configuration
Local Group Port Net Remote Station IP
Group Type Status Number Group Address Address
------ ----- ----------------- ------ ------ ------- ---------------
1 (E) MULTI Local PRMRY (E) 1
Remote SCNDRY (E) 1 C1 6.6.6.1
E = enabled, D = disabled
BRLY config>add group 2
Local group number: [1]? 2
Point to Point connection?(Yes or [No]):
BRLY config>add local
Local group number: [1]? 2
Interface number: [0]? 1
(P)rimary or (S)econdary: [S]? p
Does this interface communicate with multiple remote groups [N]? y
BRLY config>add remote
Local group number: [1]? 2
IP address of remote router: [0.0.0.0]? 6.6.6.2
Remote router group number: [1]? 2
(P)rimary or (S)econdary: [S]? s
Station address in hexadecimal (1 - FF): [1]? c5
BRLY config>li all
BSC Relay Configuration
Local Group Port Net Remote Station IP
Group Type Status Number Group Address Address
------ ----- ----------------- ------ ------ ------- ---------------
1 (E) MULTI Local PRMRY (E) 1
Remote SCNDRY (E) 1 C1 6.6.6.1
2 (E) MULTI Local PRMRY (E) 1
Remote SCNDRY (E) 2 C5 6.6.6.2
E = enabled, D = disabled
Figure 33. BRLY Configuration for Router A (Commands entered at Router A)
Chapter 39. Using Binary Synchronous Relay (BRLY) 563
|
|
|
|
|