Filter
Top Products
bgp-subnets
new value
If you want the BGP speaker to advertise subnet routes to its neighbors, set
new value
to 1. The default is 0.
dls-ignore-lfs
new value
When set to 1, DLSw ignores the “largest frame” size bits in source-routed
frames when setting up a circuit. This avoids circuit setup problems with
some older LAN products that do not set these bits correctly. The default is
0.
ethernet-security
new value
When set to a non-zero value, zeros the padding that is applied to Ethernet
packets whose data portion is less than the physical minimum of 60 bytes.
This may be required for security reasons. Default: 0.
ip-default-ttl
#_of_packets
The TTL used in packets that are originated by the router. The default is 64.
Note: It is preferable to set this parameter with the set ttl IP configuration
command. (See the “Set” section of the “Using and Configuring IP”
chapter of
Protocol Configuration and Monitoring Reference Volume
1
.) This patch variable remains for compatibility with configurations
from older releases.
ip-mtu
bytes
This parameter limits the IP MTU size to the specified value. When this
parameter is set, the IP MTU size on a given network interface is set to the
lesser of the ip-mtu value and the largest value that network interface’s
configured frame size can accommodate.
lnm-link-via-tbport
new value
Allows LNM to link to a token-ring over an Ethernet transparent bridge (TB)
port.
When set to 1, the LNM link is allowed.
When set to 0, the default, the LNM link is not allowed.
more-lines
#_of_lines
The number of lines to display on the console when listing the IP routing
table, which uses a “more pipe” (¦).
mosheap-lowmark
new value
This parameter specifies the percentage of free MOS heap memory, at
which the device notifies the operator that an out-of-memory error is
imminent. This notification allows the operator to take action to free up MOS
heap memory before the device receives an error and stops.
When the operator receives notification, the operator can reconfigure the
router and then reboot, minimizing the outage to the network. Specifying 0
for this parameter suppresses this warning.
Valid Values: 0to100
Default Value: 10
ospf-import-rate
rate
Number of routes imported per second.
ping-size
bytes
The size of the data portion (that is, excluding IP and ICMP headers) of the
ICMP PING packet that is sent via the IP>ping command. Default: 56
bytes. (The size of the PING data can also be entered as a parameter of
CONFIG Commands
Chapter 6. Configuring and Monitoring the CONFIG Process 73