Filter
Top Products
Syntax:
set
max-reserved-bandwidth
traffic-type
peak-cell-rate
sustained-cell-rate
qos-class
max-burst-size
Example:
ARP entry 'identifier' config> set ?
MAX-RESERVED-BANDWIDTH
TRAFFIC-TYPE
PEAK-CELL-RATE
SUSTAINED-CELL-RATE
QOS-CLASS
MAX-BURST-SIZE
See Configuring and Monitoring Quality of Service (QoS) in
Using and Configuring
Features
for detailed information about the QoS parameters.
List
Use the list command to display information about ARP configuration.
Remove
Use the remove command to remove an configured MAC address or Route
Descriptor LE-ARP entry.
Select the ARP entry number to be removed from the list provided.
Syntax:
remove
arp-entry-number
RIF-Timer (for Token-Ring Forum-compliant LEC only)
Use the RIF-Timer command to set the maximum amount of time that information
in the RIF is maintained before it is refreshed. Range is 0 to 4096. The default is
120 seconds.
Syntax:
rif-timer
value
Example:
rif-timer 100
Source-Routing (for Token-Ring Forum-Compliant LEC only)
Use the source-routing command to enable or disable end station source-routing.
Source routing is the process by which end stations determine the source route to
use to cross source routing bridges. Source routing allows the IP, IPX, and
AppleTalk Phase 2 protocols to reach nodes on the other side of the source route
bridge.
Configuring Forum LE Clients
Chapter 24. Configuring and Monitoring LAN Emulation Clients 297