Filter
Top Products
To reload the current configuration, press Enter. To load another configuration,
enter the load name at the prompt.
Loading using IBD Load Image "load name"
If you specify an incorrect or nonexistent load name, the system issues the
following message: No such load and returns you to the IBD Load Name prompt.
v If you enter Token Ring, a configuration dialog similar to the following appears
on your console.
Note: If the host you specify is not directly accessible by the router, the software
will prompt you to enter the IP address of the gateway. This prompt is
shown below in parentheses.
Media (UTP/STP) [UTP]:
Speed (4/16)Mb [16Mb]:
Interface IP address: 123.175.56.119
IP Mask (FFFFFF00):
Boot from host: 123.175.68.213
Via Gateway: 123.175.56.190
Boot File Name: ibmMRNS.ldc
Using Token Ring at (6000000, 0).
Interface configured for 16Mbps & UTP
Trying host 123.175.68.213 via 123.175.56.190
file ibmMRNS.ldc
loading
....................................................
Starting at 1040000
Copyright Notices:
Copyright IBM Corp. 1994, 1997
MOS Operator Control
*
v If you enter Ethernet, you see the following:
Connector Type (AUI/RJ45)[AUTO_CONFIG]:
Interface IP Address: 123.175.56.119
IP Mask (FFFFFF00):
Boot from host: 123.175.68.213
Via Gateway: 123.175.56.190
Boot File Name: ibmMRNS.ldc
Using Ethernet at (6000000, 0)
Trying host 123.175.68.213 via 123.175.56.190
file ibmMRNS.ldc
.loading
..................................
Starting at 1040000
Copyright Notices:
Copyright IBM Corp. 1994, 1997
MOS Operator Control
*
v Booting over a WAN
If there is no CTS signal active on the WAN port that you specify, you will receive
the following message: CTS not active on WAN port #
118 MRS V3.2 Software User’s Guide