Filter
Top Products
To display this information: Enter ub at the boot prompt (>). The screen displays
information similar to the example shown below.
TFTP bootstrap configuration:
Host ibmMRNSV1 - .191, Dumping disabled, Unique dump naming off
Interface Addresses:
1: 128.196.145.191 on port 0 (Token Ring/Ethernet), mask FFFFF00
Boot Files
1: ibmMRNS.ldc on 123.175.68.213 via 123.175.56.190 for 20 secs
2: r15.1.ldc on 123.175.68.213 via 123.175.56.190 for 20 secs
3: ibmMRNS-univ.ldc on 123.175.68.213 via 123.175.56.190 for 20 secs
Dump Files:
1: "gw/ibmMRNS.dmp" on 123.175.68.213 via 123.175.56.190 for 20 secs
>
UC (Display Hardware Configuration)
Displays the following information:
v Device types available
v Console baud rate
v Size of main memory and IBD in number of Mbytes
v Base MAC address
v Router serial number
v System card serial number
v Model number
v System card part number
v System card revision (ECO) level
v Platform revision
Note: Each 2210 is programmed at the factory with a Base MAC address in
Ethernet order. If you have a Token-Ring unit, the 2210 converts the address
to Token-Ring order. However, the uc command displays the address in
Ethernet order.
Enter uc at the boot prompt (>). The screen displays information similar to the
following:
Boot device types available:
IBD
Token Ring
WAN
Console Baud Rate: 9600 (Autobaud)
Main Memory size: 8 MB
IBD (flash Memory) size: 4 MB
Base MAC Address: 000093808068
System Part Number 04H7063
System Serial Number 55554000008
System EC Level D50514
System Card Part Number 13H7771
System Card Serial Number 110653
System EC Level C99200B
UG (Go execute at address in RAM)
This option is used only by your service representative.
122 MRS V3.2 Software User’s Guide