Filter
Top Products
Example:
ATM INTERFACE> set max-mp-parties 300
trace Sets the packet tracing parameters on the interface. Packet tracing can be
enabled or disabled on a range of VPI/VCI values. Common VPI/VCI values
to trace are:
v 0/5 for signalling packets
v 0/16 for ILMI packets.
Valid Values:
ON or OFF
Default Value:
ON
You are prompted for the VPI/VCI range you want to trace.
Beginning VPI Valid Values:
0 – 255
Default Value:
0
Ending VPI Valid Values:
0 - 255
Default Value:
255
Beginning VCI Valid Values:
0 - 65535
Default Value:
0
Ending VCI Valid Values:
0 - 65535
Default Value:
65535
Example:
ATM INTERFACE> set trace on
beginning of VPI range [0]? 0
end of VPI range [255]? 0
beginning of VCI range [0]? 5
end of VCI range [65535]? 5
uni-version
Sets the User Network Interface (UNI) version used by the ATM interface
with communicating with the attached ATM switch. If the UNI versions are
configured on the ATM switch and ATM device interface to a specific
version (not AUTO-DETECT), the UNI versions must match.
If the UNI version is configured as AUTO, the ATM device attempts to learn
the UNI version to use from the switch.
In UNI AUTO-DETECT mode, if the switch does not respond to the query
for UNI version, the default is UNI 3.0. If the switch responds with a value
other than UNI 3.0 or UNI 3.1, the default is UNI 3.1.
Valid Values:
[UNI 3.0|UNI 3.1|AUTO-DETECT|None]
ATM Interface Configuration Commands (Talk 6)
Chapter 22. Configuring and Monitoring ATM 283