Filter
Top Products
You can change the configuration parameters of the following protocols and
features, but you cannot activate the changes using the reset command:
v AppleTalk
v Vines
v OSI/DECnet V
v LNM
v XTP
v WAN Restoral
v WAN Reroute
You must restart the device to activate these configuration changes.
There are also requirements for certain functions. They are:
PPP dial
circuits
A PPP dial circuit cannot be reset if any of the dial circuit parameters have
changed.
Frame Relay
dial circuits
A Frame Relay dial circuit cannot be reset if any of the dial circuit
parameters have changed.
Compression Compression requires large header and trailer sizes. Unless compression is
already enabled on some other interface, it is likely that the header and
trailer sizes will be too small. In this case, compression is disabled
automatically on the interface and an ELS message is logged (rather than
causing the entire reset interface to fail).
Bridging
v Bridging was not already active.
v NetBIOS filters are defined on the interface you are resetting.
v The reset interface caused a change to the bridge personality or behavior
(for example, adding SR port to pure TB bridge or SR-TB conversion
enabled).
BGP Use the BGP reset neighbor command to activate neighbor configuration
changes.
APPN Use the activate_new_config command to activate configuration changes.
IPX Use the IPX reset command to activate configuration changes for static
routes, static services, and filter-lists.
DNA IV Use the DNA IV set command to activate configuration changes.
SNMP Use the SNMP revert command to activate configuration changes.
Using the CONFIG (Talk 6) Process
Chapter 5. The Configuration Process (CONFIG - Talk 6) and Commands 49