Filter
Top Products
different MAC address. If you have two clients that are bridged together,
they should use different MAC addresses.
This MAC address is registered with the LES when the client joins the
ELAN.
Valid Values:
Any valid MAC address.
Default Value:
none
Example:
LEC Config> set mac-address
Use adapter address for MAC? [No]
MAC address []: 10.00.5a.00.00.01
multicast-send-avg
Sets the multicast send VCC average rate in Kbps. Used by the LEC for
reserving bandwidth on the VCC to the BUS. It specifies the forward and
backward sustained cell rate used when setting up a reserved bandwidth
multicast send VCC.
This parameter is only applicable when the multicast-send-type is reserved
bandwidth. If multicast-send-avg equals multicast-send-peak, then a
constant bit rate (CBR) multicast send is signalled. Otherwise, a variable bit
rate (VBR) multicast send is signalled. Multicast-send-avg must be less
than or equal to multicast-send peak.
A reserved bandwidth multicast send VCC may improve data transfer rates
in congested networks, but reserving bandwidth and not using it wastes
network resources.
When the multicast-send-type is reserved, then multicast-send-avg and
multicast-send-peak must be specified.
Example:
LEC Config> set multicast-send-avg 4000
multicast-send-peak
Sets the multicast send peak rate in Kbps. Used by LEC for reserving
bandwidth on the VCC to the BUS. It specifies the forward and backward
peak cell rate used when establishing a reserved bandwidth multicast send
VCC.
This parameter is only applicable when the multicast-send-type is reserved
bandwidth. If multicast-send-avg equals multicast-send-peak, then a
constant bit rate (CBR) multicast send is signalled. Otherwise, a variable bit
rate (VBR) multicast send is signalled. Multicast-send-avg must be less
than or equal to multicast-send peak.
A reserved bandwidth multicast send VCC may improve data transfer rates
in congested networks, but reserving bandwidth and not using it wastes
network resources.
When the multicast-send-type is reserved, then multicast-send-avg and
multicast-send-peak must be specified.
Example:
LEC Config> set multicast-send-peak 155
multicast-send-type
Sets the multicast send type. Specifies the method used by the LEC when
establishing the multicast send VCC.
Configuring Forum LE Clients
Chapter 24. Configuring and Monitoring LAN Emulation Clients 305