Filter
Top Products
All device and protocol configuration information related to network
interfaces is stored by interface number. Any changes made to interface
numbers will invalidate much of the device configuration information in the
protocols.
Config> add device dial-circuit
Adding device as interface 8
Defaulting Data-link protocol to PPP
Use "set data-link" command to change the data-link protocol
Use "net 8" command to configure circuit parameters
isdn-address
address-name network-dial-address network-subdial-address
Adds the local and remote numbers of the ISDN end-points that will be
communicating with your router.
address-name
Can be anything (such as a description of the port).
network-dial-address
The telephone number of the local or the destination port.
network-subdial-address
The additional part of the telephone number, such as an extension,
that gets interpreted when the interface connects to a PBX; this
parameter is optional.
Note: You can use punctuation, such as parentheses and dashes, but the
punctuation is not significant (the router uses only the numbers).
Example: add isdn-address line 1 local
Assign network dial address [0 - 32 digits]? 1 2345 67
Assign network subdial address [0 - 19 digits]? 98765
ppp-user
Adds the user profile of a remote user to the local PPP user data base. You
can add up to 500 users. You add a PPP user for each remote router or
DIALs client that can connect to the device you are configuring. You must
configure PPP users if either of the following conditions exist:
v You are using PPP authentication protocols, PPP encryption, the Dial-In
Access to LANs (DIALs) feature, or allowing users to use the dial-out
feature. You need to configure a PPP user for either type of encryption -
Encryption Control Protocol (ECP) or Microsoft Point-to-Point Encryption
(MPPE); however, MPPE does not require the encryption key.
v You want the PPP user data base to be locally stored and managed by
the device. If you want PPP user information to be obtained from a
RADIUS, TACACS, or TACACS+ server, then you should configure the
Authentication feature instead of configuring local PPP users.
Note: MPPE cannot use the RADIUS, TACACS, or TACACS+ server.
For MPPE, the PPP user data base must be local.
If ECP has been enabled for the user, you are prompted for the PPP user
name, password, IP address, and encryption key .
If the DIALs feature is in the software load, you are asked if this is a DIALs
user.
If you are adding a user for a DIALs client, then you are prompted for the
hostname, type of route, network mask, connect time, call-back information,
and dial-out capability.
CONFIG Commands
Chapter 6. Configuring and Monitoring the CONFIG Process 53
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
||
|
||
|
||
|
|
||