Filter
Top Products
-------------------------------- ----- ------ ---------- ----------
flotsam ILM 60 CIR: 0 0
Call state: Null Burst: 0 0
Call Initiated by: None DLCI: 0 Excess: 0 0
Remote party number: IE911
Remote subaddress: None
Options: I - call-ins allowed, L - learn protocols, M - multicast required
C - compression capable and operational, c - compression capable
E - encryption capable and operational, e - encryption capable
Address type: I - International, U - Unknown
Numbering plan: E - E.164, X - X.121
Subaddress format: N - NSAP, P - private
virtual-circuits
Displays all PVCs and all active SVCs with associated information that is
identical to the list permanent-virtual-circuit command.
FR 1>list virtual-circuits
Circuit Orphan Type/ Frames Frames
Number Circuit Name Circuit State Transmitted Received
------- -------------------------------- ------- ----- ----------- ----------
16 circ16 No P/A 4 8
17 Unassigned Yes @ P/I 0 0
18 flotsam No S/A 12 10
19 Unassigned Yes @ P/A 7 2
24 circ24 No P/R 0 0
P - PVC S - SVC A - Active I - Inactive R - Removed C - Congested
* - Required # - Required and belongs to a PVC group
@ - Data compression capable but not operational
& - Data compression capable and operational
LLC
Use the LLC command to access the LLC monitoring prompt. LLC commands are
entered at this new prompt. See “LLC Monitoring Commands” on page 239 for an
explanation of each of these commands.
Syntax:
llc
Note: The LLC command is supported only if APPN is in the software load.
Notrace
Use the notrace command to disable packet tracing for individual circuits or the
entire interface. This command can be used as a filter when tracing specific circuits
or interfaces is required. The default setting is to trace all circuits.
Syntax:
notrace
circuit#
circuitname
all
Monitoring Frame Relay Interfaces
442
MRS V3.2 Software User’s Guide
|
|
|
|
|
||
||
||