Filter
Top Products
You may have to press the Enter key more than once or press Ctrl-P to obtain
the * prompt.
Once at this level, you can begin to enter commands from the keyboard. Press
the Backspace key to delete the last character typed in on the command line.
Press the Delete key or Ctrl-U to delete the whole command line entry so that
you can reenter a command. See “Command History for GWCON and CONFIG
Command Line” on page 21 for information on how to access previously entered
commands.
You can also use local Telnet commands on your Telnet client to close the
Telnet connection.
Note: If you use a VT100 terminal, do not press the Backspace key, because
it inserts invisible characters. Use the Delete key.
5. Exit the router as described in “Exiting the Router”.
Reloading or Restarting the Router
Use the reload command to reboot the device and load a new copy of the code
into memory.
For example:
* reload
The configuration has been changed, save it? (Yes or [No] or Abort)
Are you sure you want to reload the gateway? (Yes or [No]): yes
Use the restart command to invoke a new configuration. For example, to change a
configuration parameter that is not dynamically configurable, you can make and
save the change, then restart the device.
Restart does dot reload the code, it simply invokes the new configuration. As a
result, restart is much faster than reload.
For example:
* restart
The configuration has been changed, save it? (Yes or [No]...orAbort)
Are you sure you want to restart the gateway? (Yes or [No]): yes
Exiting the Router
Return to the * prompt and close the Telnet connection. For example:
IP Config> exit
Config> Ctrl-P
* logout
%
You can also use local Telnet commands on your Telnet client to close the Telnet
connection.
6 MRS V3.2 Software User’s Guide
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|