Filter
Top Products
Feature
Use the feature command to access configuration commands for specific router
features outside of the protocol and network interface configuration processes.
Syntax:
feature
[
feature#
or
feature-short-name
]
All 2210 features have commands that are executed by:
v Accessing the configuration process to initially configure and enable the feature,
as well as perform later configuration changes.
v Accessing the console process to monitor information about each feature, or
make temporary configuration changes.
The procedure for accessing these processes is the same for all features. The
following information describes the procedure.
Enter a question mark after the feature command to obtain a listing of the features
available for your software release.
To access a feature’s configuration prompt, enter the feature command followed by
the feature number or short name. Table 7 lists available feature numbers and
names.
Table 7. IBM 2210 Feature Numbers and Names
Feature
Number
Feature
Short Name
Accesses the following
feature configuration process
0 WRS WAN Restoral/Reroute
1 BRS Bandwidth Reservation
4 VCRM Virtual Circuit and Resource Management
7 CMPRS Data Compression
9 DIALs Dial-In-Access to LANs
10 AUTH Authentication
12 LAYER Layer 2 Tunneling Protocol
Once you access the configuration prompt for a feature, you can begin entering
specific configuration commands for the feature. To return to the CONFIG prompt,
enter the exit command at the feature’s configuration prompt.
List
Use the list command to display configuration information for all network interfaces,
or configuration information for the router.
Syntax:
list
configuration
devices
isdn-address
patches...
ppp_users...
CONFIG Commands
68
MRS V3.2 Software User’s Guide
|||