Filter
Top Products
frame-ext-seq-mode
frame-window-size
min-collission-timer
min-connect-timer
min-recall-timer
network-type...
n2-timeouts
packet-size...
packet-ext-seq-mode
request-reverse-charges
reset...
restart...
standard-version
suppress-calling-addresses
throughput-class-negotiation
t1-timer
t2-timer
truncate-called-addresses
truncate-called-addr–size
Add
Use the add command to add an X.121 address, a DDN X.25 Address, a protocol
configuration, or a PVC definition.
Syntax:
add
address
bi-cugs
cugs
htf-address
protocol
pvc
address
Adds an X.121 address translation for a protocol supported in the
configuration of the router. The prompts that appear depend on the protocol
address that you are adding. (See the following examples.) The protocol
address and X.121 address being entered represent the protocol and X.121
DTE address of the remote DTE connecting to the router X.25 interface.
The mapping of a protocol address and the X.121 address must be unique
unless the protocol is APPN or DLSw. A protocol address cannot map to
more than one X.121 address. Also, a specific X.121 address cannot map
to more than one protocol address. The set address command is used to
set the local X.25 address. After setting the local X.25 address, you can use
Configuring the X.25 Network Interface
Chapter 27. Configuring and Monitoring the X.25 Network Interface 341