Filter
Top Products
3. Use the net number from the previous step to determine the associated MAC
address
4. In talk 6, add an ARP entry to establish a static IP address to MAC address
relationship
Additional Considerations
ELS Messages Containing IP Addresses
ELS messages containing an IP address which matches the IP address of the
remote workstation will not be remote-logged, even if configured for remote-logging,
and may appear under talk 2. These messages are discarded instead of being
remote-logged in order to prevent excessive UDP packets from being sent on the
network.
*t5
+pip
IP>ping 192.9.200.1
PING 192.9.200.20 -> 192.9.200.1: 56 data bytes, ttl=64, every 1 sec.
56 data bytes from 192.9.200.1: icmp_seq=0. ttl=64. time=0. ms
----192.9.200.1 PING Statistics----
1 packets transmitted, 1 packets received, 0% packet loss
round-trip min/avg/max = 0/0/0 ms
IP>dump
Type Dest net Mask Cost Age Next hop(s)
.
Dir* 192.9.200.0 FFFFFF00 1 102305 Eth/0
.
IP>exit
+int
Self-Test Self-Test Maintenance
Net Net' Interface Slot-Port Passed Failed Failed
0 0 Eth/0 Slot: 1 Port: 1 1 0 0
.
+p arp
ARP>dump
Network number to dump [0]? 0
Hardware Address IP Address Refresh
02-60-8C-2D-69-5D 192.9.200.1 2
Ctrl-P
*t6
config>p arp
ARP config>add entry
Interface Number [0]? 0
Protocol [IP]? IP
IP Address [0.0.0.0]? 192.9.200.1
Mac Address []? 02608C2D695D
ARP config> list entry
Mac address translation configuration
IF # Prot # Protocol -> Mac address
0 0 192.9.200.1 -> 02608C2D695D
ARP config>exit
Config>
Ctrl-P
*restart
Are you sure you want to reload the gateway? (Yes or [No]): Yes
(after reload, static ARP entry is active)
Figure 12. Example of Setting Up a Static ARP Entry
Using ELS
162
MRS V3.2 Software User’s Guide