Filter
Top Products
v The set command-delay-timeout command specifies the amount of time the
router waits to initiate or answer a call after it turns on DTR.
v The set connect-timeout command specifies the number of seconds allowed for
a call to be established.
v The speed command sets the maximum DTE speed for the modem.
v The modem-init-string command allows flexibility in modem configuration to
accommodate user or external equipment requirements.
v When you have finished configuring the interface, you can use the list command
to display your configuration.
Adding Dial Circuits
Dial circuits are mapped to V.34 serial line interfaces. You can map multiple dial
circuits to one serial line interface.
The V.34 interface supports multiple types of dial circuits. To add a dial circuit use
one of the following commands from the Config> prompt.
v add device dial-circuit
v add device dial-in
v add device dial-out
The software assigns an interface number to each circuit. You will use this number
to configure the dial circuit.
Example:
Config> add device dial-circuit
Adding device as interface 6
Note: Dial circuits default to the Point-to-Point protocol (PPP). Although the set
data-link command can be used to set the datalink of a dial circuit to Frame
Relay, only PPP dial circuits are supported over V.34.
Configuring Dial Circuits
This section describes how to configure a dial circuit. For a complete description of
the dial circuit commands, see “Chapter 47. Configuring and Monitoring Dial
Circuits” on page 643. To configure the dial circuit, do the following:
1. Display the Circuit Config> prompt by entering the network command
followed by the interface number of the dial circuit. You can use the list devices
command at the Config> prompt to display a list of the dial circuits that you
added. For example:
Config>network 6
Circuit configuration
Circuit Config>
2. Map the dial circuit to a V.34 interface. The Base net is the V.34 interface
number. For example:
Circuit Config>set net
Base net for this circuit [0]? 0
3. Specify the address name of the remote router to which the dial circuit will
connect. You must use one of the names you defined using the add
v34-address command. For example:
Circuit Config>set destination
Assign destination address name []? newyork
Using V.34
Using V.34 597