Filter
Top Products
Min frag size
This is the minimum size of the fragments (in bytes) the software
creates when a packet exceeds
Max fragment size
.
Valid Values: 100 to 3 000
Default Value: 375
Max number of active links
Specifies the configured maximum number of links in the MP virtual
link (also known as
bundle
).
Valid Values: 1to64
Default Value: 2
Monitoring MP Interface Status
To determine the status of all the MP interfaces in your device, use the
configuration command in talk 5 (see “Configuration” on page 130).
Accessing the MP Monitoring Commands
To access the MP monitoring commands:
1. Enter talk 5 at the * prompt.
2. Enter net
n
, where
n
is the number of the MP interface that was created in talk
6 using add device multilink-ppp command.
Multilink PPP Protocol Monitoring Commands
Table 65 shows the monitoring commands available for an MP interface.
Table 65. MP Monitoring Commands
Command Function
? (Help) Displays all the commands available for this command level or lists the
options for specific commands (if available). See “Getting Help” on page 10.
List Displays BAP, BACP, BOD, and MP statistics, errors, and other information.
Exit Returns you to the previous command level. See “Exiting a Lower Level
Environment” on page 11.
List
Use the list command to display information about the MP interface including
bandwidth allocation statistics.
Syntax:
list
bacp
bap
control bacp
control bod
Configuring MP
Chapter 35. Configuring and Monitoring Multilink PPP Protocol (MP) 519
|
|
|
||