Filter
Top Products
Syntax:
llc
Remove
Use the remove command to delete any PVC, Required PVC group, or
protocol-address previously added using the add command.
Syntax:
remove
permanent-virtual-circuit...
protocol-address
pvc-group
switched-virtual-circuit
circuit-name
permanent-virtual-circuit
pvc#
Deletes any configured PVC in the range 16 to 1007.
Notes:
1. When you delete a PVC that is running compression, the interface
decreases the count of active compression PVCs. If this action brings
the count of compression PVCs below the limit, you will receive a
message to that effect.
2. When you delete a PVC that is running encryption, the interface
decreases the count of active encryption PVCs.
Note: Encryption support is optional. If your software load does not
include encryption, you will not see encryption-related
parameters.
protocol-address
Deletes any configured protocol addresses (static ARP entries). This
parameter prompts you for different information depending on the type of
protocol that you are adding.
Example:
remove protocol-address
Protocol name or number [IP]?
IP protocol:
IP Address [0.0.0.0]?
Circuit Name or Number [16]?
IPX protocol:
Host Number (in hex)[]?
Circuit Name or Number [16]?
AppleTalk Phase 2 protocol:
Network Number (1-65279) []?
Node Number (1-253) []?
Circuit Name or Number [16]?
DN protocol:
Node address [0.0]?
Circuit Name or Number [16]?
Configuring Frame Relay Interfaces
426
MRS V3.2 Software User’s Guide
||
|
|
|
|
|
|
|
|
|