Filter
Top Products
Appendix A. Quick Configuration Reference
Important
If you are attempting to configure or monitor your IBM 2210 and your service
terminal is unreadable, see “Service Terminal Display Unreadable” in IBM
2210 Nways Multiprotocol Router Service and Maintenance Manual.
Quick Configuration Tips
Making Selections
On the panels that you view when using the Quick Configuration program, the
information shown in brackets, [], is the default. For example:
Configure Bridging? (Yes, No, Quit): [Yes]
v To use the default Yes, press Enter.
v To use a value other than the default, such as No or Quit, choose from the
values in the parentheses.
v If no value appears in the brackets, there is no default and you must type a
value.
Integrated Modems
Integrated modems are automatically configured.
Exiting and Restarting
v To restart the current Quick Configuration section at any time, type r. For
example, if you are in the Interface Configuration section, type r and press Enter
to return to the beginning of that section.
v To exit Quick Configuration, type q and press Enter. The Config> prompt will
appear.
v To restart Quick Configuration from the Config> prompt, type qc and press
Enter.
When You’re Done
v Once you have completed your configuration, you must restart the IBM 2210 for
the configuration to take effect. At the end of the Quick Configuration program,
you are given this option.
Starting the Quick Configuration Program
The following sections describe sample configurations using the Quick Configuration
program (qconfig).
To start the quick configuration program, enter qc at the Config> prompt.
The program displays the following panel after starting.
© Copyright IBM Corp. 1994, 1998 651