Filter
Top Products
Table 14. Boot Options
Option Name Description
B Boot using stored
Configuration
Boots automatically using the configuration stored in
TFTP or in the IBD.
BC Boot to Config-only Mode
using console queries
Displays prompts to manually boot the 2210 and
then enters Config-only mode, allowing you to begin
configuring the 2210.
BM Boot using Console
Queries
Displays prompts to manually boot the 2210.
Table 15 on page 115 describes these prompts.
BN Boot, but do not run,
using console queries
Used by field personnel for debugging. Boots and
returns to the Bootstrap Monitor, but does not start
the load.
BP Boot using BOOTP Displays the prompts to boot using the Bootstrap
Protocol.
D Dump using stored
Configuration
This feature is not currently available on the 2210
DIAG Initiate IBM extended
diagnostics
Starts the internal tests. When internal tests are
complete, you have the option of continuing with the
System Extended Checkout (Internal and External
Tests), the WAN/LAN Wrap Menu, or Diagnostic
Utilities. You can exit and reboot at any time.
DM Dump using Console
Queries
This feature is not currently available on the 2210.
UB Display boot
Configuration
Displays the static RAM TFTP bootstrap
configuration.
UC Display Hardware
Configuration
Displays the information on the hardware
configuration including device types, baud rate,
memory sizes, base MAC address, part numbers,
serial numbers, and revision levels.
UG Go and Execute at
Address in RAM
This option is used by field service personnel.
LC Load Configuration
Memory
Loads configuration memory from a host on the
network.
CC Clear Configuration
Memory
Clears the configuration in SRAM.
ZB ZModem Boot Downloads and uploads router code through the
service port.
ZC ZModem Configuration
Memory Load
Loads configuration memory through the service
port.
Boot Option Prompts
The following section explains each of the boot options in detail.
Table 15 on page 115 describes the prompts that appear when you boot the 2210.
These prompts vary depending on your hardware configuration and the software
loaded on the 2210.
114 MRS V3.2 Software User’s Guide