Filter
Top Products
Example:
LEC Config> set reconfig-delay-min 5
reconfig-delay-max
This parameter sets the maximum delay time when LEC returns to the
initial state. This value must be ≥
reconfig-delay-min
.
Valid Values:
1-10
Default Value:
5
Example:
LEC Config> set reconfig-delay-max 9
retry-count
Sets the retry count. This is maximum number of times that the LEC retries
an LE_ARP_REQUEST for a specific frame’s LAN destination. If no ARP
response is received after the specified number of retries, then the entry is
purged from the LE ARP cache.
Valid Values:
0, 1, or 2
Default Value:
1
Example:
LEC Config> set retry-count 2
selector
Specifies the selector portion of the client’s ATM address. The combination
of ESI and selector must be unique among all LANE components on the
device. By default, a unique selector is selected for the configured ESI.
Valid Values:
Any octet, in hexadecimal, that is not in use by another LANE
component with the same ESI.
Example:
LEC Config> set selector 01
trace Enables tracing for the LEC. To perform packet tracing, three steps are
required:
1. Enable packet tracing system (under ELS)
2. Enable tracing on the LEC subsystem (under ELS)
3. Enable packet tracing on the desired LECs (using this command).
Valid Values:
Enable or Disable
Default Value:
Disable
Example:
Token Ring LEC config>set trace
Trace packets on the LEC? [No]?yes
unknown-count
Sets the unknown frame count. This is the maximum number of frames for
Configuring Forum LE Clients
Chapter 24. Configuring and Monitoring LAN Emulation Clients 307