Filter
Top Products
Reference
3-34 GB1400 User Manual
Window Process Set Up
The Window measurement process may be configured using the four parameters
in the WINDOW Menu:
MODE: Defines window length in terms of "bits" or "seconds".
BITS: Window length in bits.
SECOND: Window length in terms of hours, minutes, and seconds.
REPORT: Turns end-of-window reports on or off.
If you want to measure Window results, you must set the MODE parameter, and
depending on your MODE selection, either the BITS or SECOND parameter. In
addition, if you want to generate end-of-window reports you must also set the
REPORT parameter to on.
Procedure
1. Press F1 to enter the Menu system.
2. Select the WINDOW Menu (F3).
3. Within the WINDOW Menu, set up:
a. MODE (F2) and
b. either BITS (F3) or SECOND (F4).
4. Press MORE (F1) to see the next page of the WINDOW Menu.
5. If you are using a printer, set the REPORT parameter (F2) to on or off as
required.
6. When WINDOW Menu setup is complete, press F1 multiple times to exit
the Menu system.
See later in the this chapter for more information on setting up the WINDOW
Menu.