Filter
Top Products
Pattern Editing Software
H-6 GB1400 User Manual
The HELP system indicates that only "filename.pat" files can be opened. This is
not true. Although ".pat" is the default extension and should be used for saving
all gigaBERT files, there may be different extensions that may be used for the
packetBERT200 depending on the version of firmware of the instrument. All
possible filename extensions are listed in the "List of File Type" box in the File
Open and File Save menus. Consult your packetBERT200 manual for filenames
that are valid.
To Remove the Tektronix Pattern Editor
1) Start Windows and remove the Tektronix group and all of its entries.
2) Save the configuration.
3) Open File Manager
4) Delete the following:
The MLPE directory and PATTERNS sub directory and all entries in
each.
Delete the MLPE.INI file in the WINDOWS directory.
5) The program edits the PATH statement in the AUTOEXEC.BAT file to add
the WINDOWS\SYSTEM directory to the path. You can edit the file to remove
this statement, or leave it.
There are no other files or changes made by the program.
NOTE:
For technical support or questions pertaining to the installation of this program,
call Tektronix at 800-643-2167 or 978-256-6800.
Microsoft Windows is a trademark of Microsoft Corporation.
National Instruments is a trademark of National Instruments Corporation.