Filter
Top Products
Reference
GB1400 User Manual 3-49
F1 F2 F3 F4
MORE LENGTH MODE REPORT
3. Press F2 and you will see the LENGTH function:
F1:ESC F2<- ->F3 F4:SET
TEST LENGTH = 01:00:00
NOTE: Your display may show a different value.
4. The TEST LENGTH function allows you to set the length of timed tests in
terms of hours, minutes, and seconds. Notice that either the hours, minutes,
or seconds field will be flashing. To change the value of the flashing field,
press the pattern up/down keys. To change the value of another field, use the
F2 or F3 key to select this field and then use the pattern up/down keys to
change its value.
In this example, we will change TEST LENGTH from 1 hour (as shown
above) to 30 minutes, as shown below:
F1:ESC F2<- ->F3 F4:SET
TEST LENGTH = 00:30:00
5. Note that there are two ways to exit a function like TEST LENGTH. The
normal way is to press F4 to lock in your changes and exit the function.
However you can also exit most functions without making any setup change
by pressing F1 to "escape". In this example we'll press F4 and see the
following:
F1 F2 F3 F4
MORE LENGTH MODE REPORT
6. Notice that we've returned to the TEST Menu. Next press F3 to enter the
MODE function and see the following:
F1:ESC F4:SET
TEST MODE = UNTIMED
7. Note that the MODE function has only one field and therefore does not use
the F2 and F3 direction keys. Press the pattern up key one time to select the
timed test mode and see the following: