Filter
Top Products
Pattern Editing Software
GB1400 User Manual H-3
• The editor uses a proprietary editor and therefore cannot share data with
other applications via the Clipboard.
• The editor will not work with the GB660.
List of Files on this Disk
SETUP.EXE
SETUP.INS
README.DOC
MLPE.Z
MLPE.INI
MLPE.BMP
FPGRID10.VBX
Please verify that the above files are on this disk. If any are missing, please
contact Tektronix.
If you are using an alternate shell, such as Norton Desktop
In some cases the program will not install properly if an alternate shell, such as
Norton Desktop is used as your Windows shell. If the program gives error
messages, try installing the program using the standard Windows
PROGMAN.EXE shell. If the installation proceeds normally without any errors
but the program fails to run properly, check the following:
If you are using Norton Desktop 3.0, in the Tektronix program group select
(single mouse click) the Pattern Editor icon and then select PROPERTIES in the
GROUP menu. Select the ADVANCED icon. If the default path and directory
was chosen for installation, see if the listed STARTUP DIRECTORY shown is:
(drive on which Windows is installed):\MLPE\
If there is a "\" after MLPE then edit the entry to remove it.
The correct entry should look like the following:
(drive on which Windows is installed):\MLPE
Choose OK
The same may have to be done for the README icon if an error message
indicating that the README cannot be found.
The program will run properly now.
If the program should stop working
If the program has been installed and was working properly and then at a later
time fails to run properly, check to see if the "MLPE.INI" file in the WINDOWS