Filter
Top Products
Reference
GB1400 User Manual 3-39
End-of-Test Reports
When End-of-Test reports are enabled, one End-of-Test report will be generated
each time the end of a Test interval is reached. This can occur automatically,
when timing mode is set to Timed or Repeat, or manually when the user stops an
Untimed test by pressing the CLEAR key. Use the REPORT parameter in the
TEST Menu to enable or disable End-of-Test reports. An example End-of-Test
report is shown below.
Example End-of-Test Report
--------------------------------------------------------------------------------------------------
Tektronix, Inc. GB-1400 TEST SUMMARY Jun/14/99 02:42:48
TEST MODE: TIMED FREQ: 100.0 MHz ERROR THRES: E-05
TIME ALARMS PERFORMANCE
START Jun/14/99 02:43:26 SIG LOSS OS US 0 0.0%
STOP Jun/14/99 0s:43:31 SYNC LOSS OS SES 0 0.0%
ELAPSED 000-00:00:05 PHASE ERR OS TES 5 100.0%
ES 5 100.0%
ERRORS/BITS EFS 0 0.0%
TOTAL ERRS 000050000 AVG RATE 1.0E-04 DM 0 0.0%
TOTAL BITS 500002816 CUR RATE 1.0E-04
--------------------------------------------------------------------------------------------------
You can set up the Analyzer to generate End-of-Test Reports as follows:
Procedure to Enable or Disable End-of-Test Reports
1. Complete the basic report setup procedure.
2. Press F1 to enter the Menu system.
3. Select the TEST Menu (F2).
4. Select the REPORT parameter (F4).
5. You may now either enable End-of-Test reports by selecting END OF
TEST or EOT/ERROR; or disable End-of-Test reports, by selecting
NONE.
6. Press F4 to lock in you selection.
7. Press F1 multiple times until you have exited the Menu system.