Tektronix 071-0590-00 Welding System User Manual


 
Pattern Editing Software
H-2 GB1400 User Manual
Minimum Requirements:
Microsoft Windows 3.1 or later running on a 386 or faster machine with 4 Mb of
memory, For reasonable speed, a 486 DX or DX2 with at least 8 Mb of memory.
At least 2 Mb of free hard disk space.
gB700 Tx or Rx with 128K memory.
gB1400/1600 Tx or Rx with at least 256K memory.
A PB200.
One free RS-232 port or a National Instruments GPIB card with associated driver
and software.
List of Features
Editing capability in excess of 1 Mb. File size is in increments of 1 bit.
Files can be displayed, edited, and saved in Hex, Decimal, Octal, or Binary
formats.
Data can be saved or displayed LSB (Least Significant Bit) or MSB (Most
Significant Bit) first.
Files saved in one format can be converted to any of the other three formats.
Multiple editing windows can be open simultaneously to allow working on
several files at once.
The editor runs under Microsoft Windows with full Windows printing
capability.
Extensive built-in help.
Data can be uploaded to a gB700/1400/1600 Tx or Rx via RS-232 or GPIB.
Uploaded data can be saved in any memory location for any memory
configuration, even while the instrument is performing tests.
Data can be downloaded from a gB700/1400 Tx or Rx via RS-232 or GPIB.
Downloaded data can be saved to disk for safe keeping or later editing, even
while the instrument is performing tests.
Data can be saved to disk and read from disk in a format compatible with the
PB200, both current single file per disk and future multiple files per disk
formats.
The editor has full cut, paste, and copy facilities along with a last action
delete UNDO.
The editor has full find and replace functions.
Replaced data can be a different length than the data it is replacing.
What the editor cannot do: