Filter
Top Products
Tutorial
GB1400 User Manual 2-31
Instrument Connections and Controls
GB1400 Analyzer (Receiver)
GB1400 Generator (Transmitter)
CLOCK
CLOCK
DATA
DATA
DATA
CLOCK
Data Threshold connection (required
for single-ended signals)
1. Setup units with default settings
Note: Resetting the unit to factory defaults is used infrequently. It helps simplify
instructions on this beginners lab. A customer would not normally do this as
they would lose their stored setups.
To reset the units to their factory default setting, you must hold down three
separate keys while turning on the front panel power switch. Power the
Generator while pressing and holding its VIEW ANGLE, MSB 1 and (PATTERN) CLEAR
keys simultaneously. Release the key after the message Default Settings appears in
the display. Repeat this procedure with the Analyzer. This will force both the
Generator and Analyzer to power up using factory default settings.