Filter
Top Products
Remote Commands
C-100 GB1400 User Manual
edit_begin [n]
Edit Begin. You must issue this command to the instrument before starting an editing
session. In effect this command loads the contents of a word memory location specified
by n into a scratch pad memory location. Once in the scratch pad memory it can be
edited, uploaded to the controller, or saved to the same or a different memory location.
You also must issue the edit_begin command before downloading a word pattern to the
instrument.
Min. Abbr. edit_b
Arguments n <NR1>, a decimal number in the range -1 to 9, where -1
indicates the current word pattern and 0 through 9 indicate the
memory locations.
-1 only (1M and 512K modes)
-1 to 2 (256K mode)
-1 to 5 (128K mode)
-1 to 9 (64K mode)
Example edit_begin 2