DEFINITY Enterprise Communications Server Release 7
Maintenance for R7r
555-230-126
Issue 4
June 1999
Maintenance Object Repair Procedures
9-359BRI-SET, ASAI-ADJ, BRI-DAT
9
When plugged into the port in this manner, the test set establishes a signaling
link connection with the switch and attempts to complete SPID initialization by
using the Service SPID administered for the system (see the System
Maintenance Administration Form). If the test set displays the correct
administered port address for the endpoint or adjunct under test, the test passes
(see Service SPID Display, which follows). If after one-minute nothing is
displayed on the test set, the test fails.
The abbreviations used in (Service SPID Display) have the following meanings:
SPID Facility Test
Test Result Description / Recommendation
FAIL No response is received from the endpoint.
1. Check the physical wiring between the switch and the
endpoint or adjunct.
2. If test continues to fail, escalate to the next tier.
FAIL Display does not match administered port address for the
endpoint or adjunct.
1. Change station administration for endpoint or adjunct to
match displayed port address.
2. If test continues to fail, escalate the problem.
PASS Display matches administered port address for the endpoint or
adjunct.
For BRI endpoints:
1. Verify that the SPID values administered in the switch and
the endpoint are consistent.
2. If the SPID values are correct, replace the endpoint.
3. If test continues to fail, escalate the problem.
For ASAI adjuncts:
1. Verify that the TEI values administered in the switch and the
adjunct are consistent.
2. If the TEI values are correct, consult the recommended
repair procedures of the manufacturer for the adjunct.
3. If test continues to fail, escalate the problem.
UU Universal Cabinet number
(1 for PPN, 2 - 44 for EPN)
C Carrier (A,B,C, ...)
SS Slot (01, 02, ...)
