DEFINITY Enterprise Communications Server Release 7
Maintenance for R7r
555-230-126
Issue 4
June 1999
Maintenance Commands
8-175reset board
8
The following display shows a typical result when
release board 01c07
is
entered.
reset board
reset board UUCSS [repeat
#
]
!
CAUTION:
This command can be service disrupting and may cause extraneous
alarms. Effects of a reset vary depending upon the type of object being
reset and upon whether the component is duplicated. Consult the section in
Chapter 9, ‘‘ABRI-PORT (ASAI ISDN-BRI Port)’’
on the relevant maintenance
object for details.
When a port circuit pack is specified, the reset board command performs a
software reset of every administered port on the circuit pack. All ports must be
busied out before the port circuit pack is reset.
On Critical Reliability systems (duplicated PNC), reset of an Expansion Interface,
Switch Node Interface, Switch Node Clock, or DS1 Converter circuit pack on the
active PNC is not permitted. Standby components must first be busied out before
entering the reset.
Cabinet number and repeat both default to 1. For more information see Common
Input Parameters and Common Output Fields at the beginning of this chapter.
reset disk
reset disk [C]
release board 01C07
COMMAND RESULTS
Port Maintenance Name Alt. Name Result Error Code
01C07 ANL-BD PASS
01C0701 ANL-LINE 5409 PASS
01C0702 ANL-LINE 5416 PASS
01C0703 ANL-LINE 5421 PASS
Command successfully completed
