DEFINITY Enterprise Communications Server Release 7
Maintenance for R7r
555-230-126
Issue 4
June 1999
Maintenance Object Repair Procedures
9-1633TAPE
9
Replacing the TAPE Circuit Pack
For a Simplex SPE:
a. Enter
busyout host-adapter
. The Host Adapter should be "busied out" to
prevent other applications from trying to access the tape or the disk. The
Tape circuit pack supplies +12V to the Disk circuit pack so when it is
removed, the Disk circuit pack will also go out of service.
b. Replace the Tape circuit pack and insert the tape cartridge into the new
Tape circuit pack.
c. Issue the
reset host-adapter
command. This may take up to 3 minutes to
complete since it waits for the tape to retension.
d. Issue the
release host-adapter
command.
e. Issue the
status spe
command and check that the status screen indicates
that the tape and disk are now in service.
For a Duplicated SPE:
a. See ‘‘Replacing SPE Circuit Packs’’ in Chapter 5.
b. After the standby SPE is powered up and fully refreshed, test the standby
tape using the
test tape long
command.
Error Log Entries and Test to Clear Values
Table 9-616. TAPE Error Log Entries
Error
Type
Aux
Data
1
Associated Test
Alarm
Level
On/Off
Board Test to Clear Value
1 (a) any Tape Reset (#894) MINOR OFF reset tape a|b
2
18 (b) 0 Busyout Tape (#817) WARNING OFF release tape a|b
2
250 (c) 0 Reset Tape (#894) WARNING OFF reset tape a|b
2
257 (d) any Tape Looparound
(#814)
WARNING OFF test tape a|b
2
sh rep 2
513 (e) any Tape Diagnostics
(#813)
MINOR ON test tape a|b
2
sh rep 2
526 (f) 0 Busyout Host-adapter WARNING OFF release host-adptr a|b
2
529 (g) 0 WARNING OFF reset tape a|b
2
769 (h) any Tape Looparound
(#814)
MINOR ON test tape a|b
2
sh rep 2
Continued on next page
