DEFINITY Enterprise Communications Server Release 7
Maintenance for R7r
555-230-126
Issue 4
June 1999
Maintenance Object Repair Procedures
9-1119M/T-DIG (Maintenance/Test Digital Port)
9
Table 9-445. TEST #566 Hook State Inquiry
Error
Code Test Result Description/ Recommendation
1 ABORT Switch hook audit timed out. No response was received from the circuit
pack for information about the switch hook state.
1. Retry the command at 1-minute intervals a maximum of 5 times.
2. If the test continues to abort, replace the circuit pack and repeat the
test.
3. If the test continues to abort, escalate the problem.
2100 ABORT System resources required to run this test are not available.
1. Retry the command at 1-minute intervals a maximum of 5 times.
2. If the test continues to abort, escalate the problem.
Any FAIL Internal System Error This test should never return a failure.
1. Retry the command at 1-minute intervals a maximum of 5 times.
2. If the test continues to fail reset the circuit pack via the busy-out
board UUCSS, reset board UUCSS, release board UUCSS
command sequence.
3. Retry the command at 1-minute intervals a maximum of 5 times.
4. If the test continues to fail, escalate the problem.
PASS Call processing and Maintenance/Test Digital Port maintenance software
agree on the Maintenance/Test Digital Port hook state.
Continued on next page
