DEFINITY Enterprise Communications Server Release 7
Maintenance for R7r
555-230-126
Issue 4
June 1999
Maintenance Object Repair Procedures
9-1016MAPD-BD (MAPD Interface Circuit Pack TN802)
9
1. If the Packet Bus is alarmed, refer to the PKT-BUS Maintenance
documentation for recommended repair procedures.
2. If the Packet Bus is not alarmed, clear the alarm and restore the
board to the Packet Bus using the following command sequence:
a. busyout board UUCSS
b. reset board UUCSS
c. test board UUCSS clear
d. release board UUCSS
3. If the problem persists, and there are no PKT-BUS alarms, then
replace the circuit pack. See ‘‘Shutting down NT on the TN802’’
before removing the circuit pack.
o. Error Type 3585 - 3601: the board received misframe errors; the Aux Data
shows the last reported misframe count.
p. Error Type 3840: the circuit pack received a bad control channel message
from the switch. This error is not service-affecting, and requires no action.
The Aux Data describes the following error events:
q. Error Type 3841: the circuit pack detected a transient hardware logic error
(for example, program logic inconsistency). This error resolves when no
faults are detected for 100 minutes. The value in Aux Data field (4358)
indicates the type of hardware problem.
r. Error Type 3842: Bad Translation RAM Location Found error; the call
continues by using another translation location. This error is not
service-affecting and requires no action.
s. Error Type 3843: LAN Receive Parity error; the circuit pack detected an
error in a received frame from the Packet Bus. These errors are most likely
caused by a Packet Bus problem, but may be due to a circuit pack fault.
1. Determine whether the problem is isolated to this circuit pack or if
the problem is caused by Packet Bus faults (see PKT-BUS).
t. Error Type 3999: the circuit pack sent a large number of control channel
messages to the switch within a short period of time.
4096 Bad major heading
4097 Bad port number
4098 Bad data
4099 Bad sub-qualifier
4100 State inconsistency
4101 Bad logical link
