Filter
Top Products
F-55
Basic operating
Step Setting Parameter
1
Set the pattern run selection parameter at
(Enabled).
(Disabled),
(Enabled)
2
Change all frequencies required to preset-
speed frequencies.
(Preset-speed #1 to #7)
(Preset-speed #8 to #15)
(Preset-speed operation mode)
(Preset-speed #1 to #15 control
mode)
3
Set the required operation time at each of
the set operation frequencies.
(Preset-speed #1 to #15
operation continuation mode)
(Preset-speed #1 to #15
operation time)
Set the sequence of each speed
This sequence following three methods.
Select a run/stop operation from the
pattern run mode
(
Patterned operation canceled during stop
)
Pattern run is reset by stop/switching
operation before operating restarts.
(
Patterned operation continued during stop
)
Pattern run is started by stop/switching
operation. The system stops temporarily on
completion of every routine, then proceeds to
the next routine.
Select a pattern group, and then set the
sequence of each speed
(Cycle number of pattern group #1)
(
Pattern group #1 selection #1 to #8
)
(Cycle number of pattern group #2)
(
Pattern group #2 selection #1 to #8
)
(Cycle number of pattern group #3)
(
Pattern group #3 selection #1 to #8
)
(Cycle number of pattern group #4)
(
Pattern group #4 selection #1 to #8
)
4
According to the required parameter
group, select pattern group #1, #2, #3 or
#4 from input terminal selection to
. If you set at at
item 3 above, select step trigger signals
from . Selecting pattern
run continuation signals makes it possible
to select a start/stop method.
, (Pattern group #1)
, (Pattern group #2)
, (Pattern group #3)
, (Pattern group #4)
, (Pattern run continuation signal)
, (Pattern run trigger signal)
5
Monitor displayed during pattern run
During pattern operation, the following run information is displayed before the normal display.
Pattern run switching output (output terminal function : 36, 37)
If the pattern run switching output function is selected (activated), a signal is put out on
completion of all the predetermined patterns of operation. When there is no operation
command left to be entered or the pattern operation selection signal changes, the output
terminals are turned off(in case of a-contact).
Terminal
Title Function Adjustment range Default setting
OUT1
Output terminal
selection #1
(pattern run switching output: a-contact
or
(pattern run switching output: b-contact
Note) To put out the signals to the terminal OUT2, select the parameter
.
Condition Display Meaning
Pattern group and pattern
(A)(B)
(A): Number or the pattern group
(B): Number of the pattern
Number of repetitions
Means that the current pattern operation is to
be repeated (ex. 123 times).
Preset operation speed
Frequency reference with preset-speed #1
data.
Remaining time of the
current pattern operation
Current pattern is finished in 1234 seconds.
Operation time is set for infinity or the system
is waiting for the next step command.