Filter
Top Products
J-25
Input terminal function setting (2/2)
Positive
logic
Negative
logic
Function
Speed
control
Torque
control
Position
control
V/f
constant
= = = =
Reference
section
70 71 Reservation area
72 73 Reservation area
74 75 Reservation area
76 77 Reservation area
78 79 Reservation area
80 81 Reservation area
82 83 Reservation area
84 85 Reservation area
86 87 Binary data write / /
88 89 Up/down frequency (up) (*1) /
90 91 Up/down frequency (down) (*1) /
92 93 Up/down frequency (clear) /
94 95 PUSH-type run command / / /
96 97 PUSH-type stop command / / /
98 99 Forward/reverse selection / / /
100 101 Run/stop command / / /
102 103
Commercial power/INV switching
/
104 105
Frequency reference priority switching
/
106 107 VI/II terminal priority /
108 109
Command terminal board priority
/ / / (*2)
110 111 Parameter editing enabling / / /
112 113
Control switching (torque, position)
/ / /
114 115 Deviation counter clear /
116 117 Position control forward limit LS /
118 119 Position control reverse limit LS /
120 121
Light load high-speed operation enabling
/
122 123 Reservation area
124 125 Preliminary excitation / / /
126 127
System consistent sequence
(BC: Braking command)
/
128 129
System-supporting sequence
(B: Brake release)
/
130 131
System-supporting sequence
(BA: Brake answer)
/
132 133
System-supporting sequence
(BT: Brake test)
/
134 135 Reservation area
7.2.1
(*1): Acceleration/ Deceleration time depend on or .
(*2): This function is valid when the bit 15 of communication command 1 is .
: Reservation area. Do not set at these functions.
Sensorless vector/vector with sensor : valid, : invalid