Filter
Top Products
H-4
8. 2 Changing status monitor function
Changing indication of status with power on
The standard monitor mode ( 1) indicates running frequency (with default setting) such as
"" when power is on or "" when power is off, however, such the standard indication
can be changed into arbitrary indication as shown on page H-5. When the standard monitor
indication is changed for an option, each indication appears lacking in the initial letter (, ,
etc.).
Standard monitor mode Standard monitor indication selection
Title Function Adjustment range Default setting
Monitor display mode setting
(Refer to the next page.)
Changing contents of status monitor indication
Regarding contents of status monitor indications appearing in the left column of the table on
page H-1, those marked with 2 to 5 can be changed for others. Select a desirable monitor
function from among optional monitor functions appearing on page H-5.
2 Frequency command Changeable by status monitor #1 display mode ().
3 Load current Changeable by status monitor #2 display mode ().
4 Input voltage Changeable by status monitor #3 display mode ().
5 Output voltage Changeable by status monitor #4 display mode ().
Title Function Adjustment range Default setting
Status monitor #1 display mode
(Refer to the next page.)
Status monitor #2 display mode
(ditto)
Status monitor #3 display mode
(ditto)
Status monitor #4 display mode
(ditto)
If to are set at "" (Running frequency) the running frequency is not held
in trip status.