Filter
Top Products
E-16
5.8 Upper and lower limit frequencies
Upper limit frequency
Lower limit frequency
Parameter setting
Title Function Adjustment range Default setting
Upper limit frequency
Lower limit frequency
5.9 Base frequency
Base frequency #1
Note) This is an important parameter required for setting the constant torque control area.
Title Function Adjustment range Default setting
Base frequency #1
[Hz]
Function
These parameters are used to set the upper and lower limit frequencies which are
the largest and smallest frequencies, respectively, that the inverter can output.
0 100%
Output frequency [Hz]
Frequency setting signal
The inverter does not output
any frequency exceeding the .
Upper limit frequency
0 100%
Output frequency [Hz]
Frequency setting signal
The output frequency cannot
be set below the
Lower limit frequency
Function
This parameter is used to set the base frequency according to the rated frequency of the
motor or the specification of the load.
Base- frequency voltage #1
Output frequency [Hz]
0
Output voltage [V]