Filter
Top Products
C-15
Example of control panel operation
1. Set the torque command.
Follow the steps described in the
table below to set the torque
command ().
2 Starts the motor
3. Stops the motor
Note)Pressing the Stop key causes the
motor to coast to a stop.
Control panel torque command 85%
Key operated LED display Operation
The operation frequency is displayed. (Out of operation.)
(If the monitor display mode setting parameter
is
set at [Running frequency])
Press the [MON] key to call up the first basic
parameter (Automatic acceleration/deceleration)
Select by pressing the or key.
Press the Enter key to display the parameter setting.
Select by pressing the key.
Press the Enter key to display the parameter setting.
Change the parameter setting (torque command) by
pressing key.
Press the Enter key to save the change. Then,
and the set value are displayed alternately.
Press the Monitor key three times in a row to display the
frequency.
Press the Run key to start the motor. According to the
torque, the motor accelerates to a frequency
commensurate with the load.
You can change the operation frequency anytime even
during operation, by pressing or key. (Change
of the setting)
Press the Stop key to stop the motor. The motor coasts
to a stop. (Free-run stop)
Example of typical connection
Motor
IM
G/E
CC RX
II
RR PP
S4
CC
R/L1
U/T1
Operating panel
ON: Torque control
OFF: Speed control
V/T2
W/T3
S/L2
T/L3
MON
ENT
ENT
ENT
MON
RUN
STOP