Filter
Top Products
D-2
4.1.1 How to set basic parameters [Basic parameter]
Every basic parameters can be set in the same way.
Follow the procedure below to set a basic parameter.
(Example of setting: Changing the maximum frequency from 80 to 60 Hz)
Key operated LED display Operation
The operation frequency is displayed. (Out of operation.)
(If the monitor display mode setting parameter
is
set at [Operation frequency])
Press the [MON] key to call up the first basic parameter
(automatic acceleration/deceleration).
Select "" by pressing the or key.
Press the Enter key to display the changed maximum
frequency.
Change the maximum frequency to 60 Hz by pressing
key.
Press the Enter key to save the change. Then, and the
set maximum frequency are displayed alternately.
After this,
About the parameter's adjustment range
: A value larger than the upper-limit value is entered or the value set for the currently-selected
parameter becomes larger than the upper-limit value because another parameter was changed.
: A value smaller than the lower-limit value is entered or the value set for the currently-selected
parameter becomes smaller than the lower-limit value because another parameter was changed.
If the above alarm code or blinks, change the parameter setting below the value or
above the value, respectively. When any of these alarm codes is blinking, no change can be
made to any parameter.
MON
ENT
ENT
The inverter is shipped with
certain parameters factory-set
by default.
Use "Parameter list" to select the
parameters you want to change.
If you feel puzzled about what to
do next during this operation,
press the Monitor key to return to
the first step (
is displayed).
MON
ENT
ENT
Press these keys to select the
parameter you want to change.
Press this key to display the
parameter setting.
Press this key to switch to setting
monitor mode.
Press these key to change the
parameter setting.
Press this ke
y
to save the chan
g
e.
ENT
Press this key to
display the same
parameter setting
.
MON
Press this key to
switch to status
monitor mode.
Press these keys
to call up other
parameters.
[Procedure for setting a basic parameter]