Filter
Top Products
D-3
[Basic parameter list]
No. Title Function Adjustment range
Default
setting
Reference
section
1
Automatic
acceleration/deceleration
: Manual acceleration/deceleration
: Automatic acceleration/deceleration
5.1.1
2
Automatic V/f mode setting
: (0 is always displayed.)
: Automatic torque boost + auto-tuning
: Sensorless vector control (speed) + auto-tuning
: Automatic energy-saving + auto-tuning
5.2
3
Operation command mode
selection
: Terminal block enabled
: Operating panel enabled
: Common serial communication option enabled
: Serial communication RS485 enabled
: Communication add-on cassette option enabled
5.3
4
Speed setting mode
Selection
: VI (voltage input)/II (current input)
: RR (volume/voltage input)
: RX (voltage input)
: RX2 (voltage input) (optional)
: Operating panel input
: Binary/BCD input(optional)
: Common serial communication option(FA01)
: Serial communication RS485(FA05)
: Communication add-on cassette option(FA07)
: Up-down frequency
: Pulse input #1 (optional)
5.3
5
FM terminal meter selection
5.4
6
FM terminal meter
adjustment
5.4
7
Standard setting mode
selection
:
: 50Hz standard setting
: 60Hz standard setting
: Factory default setting
: Trip clear
: Clearing accumulating operation time
: Initialization of type form information
: Memorization of user-defined parameters
: Reset of user-defined parameters
5.5
8
Forward/reverse selection
(At panel control only)
: Forward,
: Reverse
5.6
9
Acceleration time #1
() [s]
See J-28
5.1.2
10
Deceleration time #1 () [s]
See J-28
5.1.2
11
Maximum frequency
[Hz]
5.7
12
Upper limit frequency
[Hz]
5.8
13
Lower limit frequency [Hz]
5.8
14
Base frequency #1
[Hz]
5.9
15
Motor control mode
selection
: Constant torque
: Variable torque mode
: Automatic torque boost
: Sensorless vector control (speed)
: Automatic torque boost + automatic energy-saving
:
Sensorless vector control (speed) + automatic energy-saving
: V/f 5-points setting
:Sensorless vector control (speed/torque switching)
: PG feedback vector control (speed/torque switching)
: PG feedback vector control (speed/position switching)
5.10
16
Manual torque boost [%]
See J-28
5.12
Setting Type Overload protection Overload stall
protect not stall
protect stall
not protect not stall
Standard
motor
not protect stall
protect not stall
protect stall
not protect not stall
17
Selection of electronic
thermal protection
characteristics
VF motor
(special
motor)
not protect stall
5.13
18
Preset-speed # 1
[Hz]
19
Preset-speed # 2
[Hz]
20
Preset-speed # 3
[Hz]
21
Preset-speed # 4
[Hz]
22
Preset-speed # 5
[Hz]
23
Preset-speed # 6
[Hz]
24
Preset-speed # 7
[Hz]
5.14
25
Extended parameter Setting of extended 4.1.2
26
Automatic edit function To search parameters different from default value.
4.1.2