Filter
Top Products
J-27
Output terminal function setting (2/2)
Positive
logic
Negative
logic
Function
Speed
control
Torque
control
Position
control
V/f
constant
Reference
section
64 65 Ready for operation #2 / / /
66 67 Poor control power supply () pre-alarm / / /
68 69 System consistent sequence (BR: Brake release) /
70 71 In (pre-)alarm status / / /
72 73 Forward speed limit (torque control) / /
74 75 Reverse speed limit (torque control) / /
76 77 Inverter healthy output / / /
78 79
Abnormal communication alarm #2 (caused by RS485 logic or message transmission)
/ / /
80 81 Error code output #1 (6-bit output) / / /
82 83 Error code output #2 (6-bit output) / / /
84 85 Error code output #3 (6-bit output) / / /
86 87 Error code output #4 (6-bit output) / / /
88 89 Error code output #5 (6-bit output) / / /
90 91 Error code output #6 (6-bit output) / / /
92 93 Designated data output #1 (7-bit output) / / /
94 95 Designated data output #2 (7-bit output) / / /
96 97 Designated data output #3 (7-bit output) / / /
98 99 Designated data output #4 (7-bit output) / / /
100 101 Designated data output #5 (7-bit output) / / /
102 103 Designated data output #6 (7-bit output) / / /
104 105 Designated data output #7 (7-bit output) / / /
106 107 Light load signal / / /
108 109 Heavy load signal / / /
110 111 Positive torque limit / / /
112 113 Negative torque limit / / /
114 115 Output for external rush suppression relay / / /
116 117 Over travel / / /
118 119 Completion of positioning / / /
7.2.2
Sensorless vector/vector with sensor : valid, : invalid