Filter
Top Products
F-56
Set the input terminal selection at (or ): pattern run trigger signal.
Notes)
Pattern operation groups should be selected by terminal input.
When the operation command mode selection is set for panel operation, pattern group #1 is always
selected.(If you need a pattern other than pattern group #1, set input terminal selection (
) at to , and operate with the terminal input.)
If no signal is put out from any pattern run signal (all terminals are turned off), or after the
pattern run is completed, the system returns to the normal operation mode
.
When two or more pattern group numbers are entered simultaneously, the pattern group operations
are performed in ascending order and automatically switched to one another. In this case, it may
take about 0.06 seconds to search for each pattern.
10 milliseconds after a pattern operation group selection #1, 2, 3 or 4 is activated, turn on the
operation signal (F-CC). Within 10 [ms] or less, a signal for ordinary operation may be put out.
Output frequency [Hz]
[s]
F-CC
ON
OFF
0
Setting frequency
(Preset-speed #1 to #15 operation continuation mode)
=
(
Infinite
(
continued until sto
p
command is entered
))
(Preset-speed #1 to #15 operation continuation mode)
= (Continue until next step command)
Pattern group #1(S1-CC)
Pattern group #2(S2-CC)
Pattern group #3(S3-CC)
Pattern group #4(S4-CC)
ON
ON
ON
ON
ON
ON
select pattern group #1
select pattern group #2
select pattern group #3
select pattern group #4
<
Parameter setting
>
=(Pattern group #1)
=(Pattern group #2)
=(Pattern group #3)
=(Pattern group #4)
Pattern run operation
Step trigger signal
ON
OFF
Output frequency [Hz]
[s]
0
Setting frequency