Filter
Top Products
J-1
1. Basic parameters (1/2)
Vector control
Title
Communi
cation No
.
Function Adjustment range
Minimum
setup unit
Default
setting
Write during
running
Speed
control
Torque
control
Position
control
V/f
Constant
Reference
section
0000
Automatic
acceleration/deceleration
0: Manual acceleration/deceleration
1: Automatic acceleration/deceleration
0 Disabled / 5.1
0001 Automatic V/f mode setting
0: (0 is always displayed.)
1: Automatic torque boost + auto-tuning
2: Sensorless vector control (speed) + auto-tuning
3: Automatic energy-saving + auto-tuning
0 Disabled / 5.2
0003
Operation command mode
selection
0: Terminal block enabled
1: Operating panel enabled
2: Common serial communication option enabled
3: Serial communication RS485 enabled
4:
Communication add-on cassette option enabled
0 Disabled / / / 5.3
0004
Speed setting mode
selection
1: VI (voltage input)/II (current input)
2: RR (volume/voltage input)
3: RX (voltage input)
4: RX2 (voltage input) (optional)
5: Operating panel input
6: Binary/BCD input(optional)
7: Common serial communication option(FA01)
8: Serial communication RS485(FA05)
9: Communication add-on cassette option(FA07)
10: Up-down frequency
11: Pulse input #1 (optional)
2 Disabled / 5.3
0005
FM terminal meter
selection
0 33
0Enabled
/ / / 5.4
0006
FM terminal meter
adjustment
Enabled / / / 5.4
/ / /
/ / /
/ / /
/ / /
/ / /
/ / /
/ / /
/ / /
0007
Standard setting mode
selection
0:
1: 50Hz standard setting
2: 60Hz standard setting
3: Factory default setting
4: Trip clear
5: Clearing accumulating operation time
6: Initialization of type form information
7: Memorization of user-defined parameters
8: Reset of user-defined parameters
0 Disabled
/ / /
5.5
Sensorless vector/vector with sensor ( valid, :invalid)
10. Table of parameters