Filter
Top Products
J-2
1. Basic parameters (2/2)
Vector control
Title
Communi
cation No
.
Function Adjustment range
Min. unit (panel/
communication)
Default
setting
Write during
running
Speed
control
Torque
control
Position
control
V/f
Constant
Reference
section
0008
Forward/reverse selection
(At panel control only)
0: Forward,
1: Reverse
0Enabled
/ / / 5.6
0009 Acceleration time #1
0.1() 6000 [s]
0.01/0.01* See J-28 Enabled
/ 5.1.2
0010
Deceleration time #1 0.1() 6000 [s]
0.01/0.01* See J-28 Enabled
/ 5.1.2
0011
Maximum frequency 30.0 400.0 [Hz]
0.01/0.01 80 Disabled
/ / / 5.7
0012
Upper limit frequency
0.0 [Hz]
0.01/0.01 80 Enabled
/ 5.8
0013 Lower limit frequency
0.0 [Hz]
0.01/0.01 0.0 Enabled
/ 5.8
0014 Base frequency #1
25.0 400.0 [Hz]
0.01/0.01 60 Enabled
/ / / 5.9
0015
Motor control mode
selection
0: Constant torque
1: Variable torque mode
2: Automatic torque boost
3: Sensorless vector control (speed)
4:
Automatic torque boost + automatic energy-saving
5:
Sensorless vector control (speed) + automatic energy-saving
6: V/f 5-points setting
7:
Sensorless vector control (speed/torque switching)
8:
PG feedback vector control (speed/torque switching)
9:
PG feedback vector control (speed/position switching)
0 Disabled
5.10
0016 Manual torque boost
0 30%
0.1/0.01 See J-28 Enabled
5.12
Setting
Type
Overload
protection
Overload stall
0
protect not stall
1
protect stall
2
not protect not stall
3
Standard
motor
not protect stall
4
protect not stall
5
protect stall
6
not protect not stall
0017
Selection of electronic
thermal protection
characteristics
7
VF motor
(special
motor)
not protect stall
0 Disabled
/ / / 5.13
0018
Preset-speed #1
[Hz]
0.01/0.01 0.0 Enabled
/
0019 Preset-speed #2
[Hz]
0.01/0.01 0.0 Enabled
/
0020 Preset-speed #3
[Hz]
0.01/0.01 0.0 Enabled
/
0021
Preset-speed #4 [Hz]
0.01/0.01 0.0 Enabled
/
0022
Preset-speed #5
[Hz]
0.01/0.01 0.0 Enabled
/
0023 Preset-speed #6
[Hz]
0.01/0.01 0.0 Enabled
/
0024 Preset-speed #7
[Hz]
0.01/0.01 0.0 Enabled
/
5.14
Extended parameter
Setting of extended parameters listed on the
following pages
/ / / 4.1.2
Automatic edit function
To search parameters different from default value / / / 4.1.3
* Minimum setup unit is 0.1 in case of 16-bit access. Sensorless vector/vector with sensor ( :valid, :invalid)