Filter
Top Products
F-1
Extended parameters are used for sophisticated operation, fine adjustment and special purposes.
Change parameter settings, as required.
Extended parameter list => Refer to Chapter 10.
6.1 Frequency signals
6.1.1 Low-speed signal
Low-speed signal output frequency
[Parameter setting]
Tytle Function Adjustment range Default setting
Low-speed signal output frequency
[Connection diagram (Sink logic)]
6. Extended parameters
Speed control mode Torque control mode
Function
When the output frequency exceeds the frequency set with the parameter F100, an ON
signal is put out. The function of this parameter is to send a signal for exciting or releasing
an electromagnetic brake.
through the open collector terminal OUT1 or OUT2 (24 Vdc - max. 50 mA). (Default setting: OUT 1)
Output terminal setting
The low-speed signal (ON signal) output function has been assigned to the
terminal OUT1 by default. To invert output signals, it is necessary to change
the setting of the output terminal selection parameter.
[Parameter setting]
Title Function Adjustment range Set value
Output terminal
selection #1 (OUT1)
: Low speed signal(a-contact)
or
: Low speed signal(b-contact)
Note) To use OUT2 terminal, set the parameter .
P24
OUT1(or OUT2)
Ry
Output frequency [Hz]
[s]
ON
OFF
Low-speed signal output: Inversion
P24-OUT1
ON
OFF
0
Set frequency
Low-speed signal output (Default setting)
P24-OUT1