Filter
Top Products
193
Selection of operation mode and operation location
4
PARAMETERS
When switching between the Network operation mode and External operation mode
1)Set Pr.79 to "0 (initial value), 2, 6 or 7". (At the Pr.79 setting of "7", the operation mode can be switched when the X12
(MRS) signal turns ON.)
2)Set "0 (initial value) or 1" in Pr.340 Communication startup mode selection.
3)Set "66" in any of Pr.178 to Pr.184 to assign the NET-PU operation switching signal (X66) to the terminal.
4)The operation mode changes to the Network operation mode when the X66 signal turns ON, or to the External
operation mode when the X66 signal turns OFF.
Pr.340
Setting
Pr.79
Setting
X66 Signal State
Remarks
ON (NET) OFF (External)
0 (initial
value), 1
0 (initial value) NET operation mode External operation mode
1 PU operation mode Fixed to PU operation mode
2 NET operation mode External operation mode Cannot be switched to PU operation mode
3, 4 External/PU combined operation mode External/PU combined mode fixed
6 NET operation mode External operation mode
Operation mode can be switched with
operation continued
7
X12 (MRS)
ON
NET operation mode External operation mode Output stop in External operation mode
X12 (MRS)
OFF
External operation mode
Forcibly switched to External operation
mode
PU operation mode is selected when Pr.550 NET mode operation command source selection = "0" (communication option command source) and the
communication option is not fitted.
PU operation mode is selected when the X16 signal is OFF. When the X65 signal has been assigned, the operation mode changes with the ON/OFF state
of the X65 signal.
REMARKS
The priorities of Pr.79, Pr.340 and signals are Pr.79 > X12 > X66 > X65 > X16 > Pr.340.
NOTE
Changing the terminal assignment using Pr.178 to Pr.184 (input terminal function selection) may affect the other functions.
Set parameters after confirming the function of each terminal.
Parameters referred to
Pr.15 Jog speed setting Refer to page 119
Pr.4 to 6, Pr.24 to Pr.27, Pr.232 to Pr.239 Multi-speed operation Refer to page 117
Pr.75 Reset selection/disconnected PU detection/PU stop selection Refer to page 178
Pr.161 Speed setting/key lock operation selection Refer to page 256
Pr.178 to Pr.184 (input terminal function selection) Refer to page 138
Pr.190 to Pr.192 (output terminal function selection) Refer to page 144
Pr.340 Communication startup mode selection Refer to page 194
Pr.550 NET mode operation command source selection Refer to page 195