Filter
Top Products
258
Setting from the parameter unit and operation panel
(3) Disable the setting dial and key operation of the operation panel (Press [MODE] long (2s))
Operation using the setting dial and key of the operation panel can be invalid to prevent parameter change, and
unexpected start or speed setting.
Set "10 or 11" in Pr.161, then press for 2s to make the setting dial and key operation invalid.
When the setting dial and key operation are invalid, appears on the operation panel. If dial or key operation
is attempted while dial and key operation are invalid, appears. (When dial or key is not touched for 2s,
monitor display appears.)
To make the setting dial and key operation valid again, press for 2s.
REMARKS
Even if the setting dial and key operation are disabled, the monitor display and are valid.
NOTE
Release the operation lock to release the PU stop by key operation.
When setting speed by turning the setting dial, the speed goes up to the set value of Pr.1 Maximum setting (initial value:
3000r/min). Adjust Pr.1 Maximum setting according to the application.