Filter
Top Products
50
Operation panel
4.1.3 Easy operation mode setting (easy setting mode)
Setting of Pr.79 Operation mode selection according to combination of the start command and speed command can be
easily made.
Operation
example
Start command: external (STF/STR), speed command: operate with
Operation Display
1. Screen at power-ON
The monitor display appears.
2. Press and for 0.5s.
3. Turn until appears.
(refer to the table below for other settings)
4. Press to set.
Flicker ··· Parameter setting complete!!
The monitor display appears after 3s.
REMARKS
is displayed ... Why?
Setting can not be made during operation. Turn the start switch ( , STF or STR) OFF.
If is pressed before pressing , the easy setting mode is terminated and the display goes back to the monitor
display. If the easy setting mode is terminated while Pr.79 = "0 (initial setting)," the operation mode switches between the PU
operation mode and the External operation mode. Check the operation mode.
Reset can be made with .
The priorities of the speed commands when Pr.79 = "3" are "Multi-speed operation (RL/RM/RH/REX) > PID control (X14) >
terminal 4 analog input (AU) > digital input from the operation panel".
Flickering
Operation Panel Indication
Operation Method
Start command Speed command
External
(STF, STR)
Analog
voltage input
External
(STF, STR)
Analog
voltage input
Flickering
Flickering
Flickering
Flickering
Flickering
Flickering
Flickering
Flickering