Filter
Top Products
264
Check and clear of the faults history
(2) Clearing procedure
POINT
Set "1" in Er.CL Fault history clear to clear the faults history.
Operation Display
1. Screen at power-ON
The monitor display appears.
2. Press to choose the parameter setting mode.
PRM indicator is ON.
(The parameter number read previously appears.)
3. Turn until (faults history clear)
appears.
4. Press to read the currently set value.
" " (initial value) appears.
5. Turn to change it to the set value " ".
6. Press to set.
Flicker... Faults history clear complete!!
Turn to read another parameter.
Press to show the setting again.
Press twice to show the next parameter.
Parameter referred to
Pr.77 Parameter write selection Refer to page 181